Cable/DSL Router User Guide

EtherFast Cable/DSL Routers

should be the Router’s IP Address, and DNS (in "More".)

• Same as above, check the same setup values in the Status Monitor page

of the Cable/DSL Router.

4. When I enter a URL or IP address, I get a time out error.

• Check if other PCs work. If they do, ensure that your workstations IP

settings are correct (IP address, Subnet Mask, Default gateway and

DNS)

• If the PCs are configured correctly, but still not working, check the

Cable/DSL Router. Ensure that it is connected and ON. Connect to it

and check its settings. (If you cannot connect to it, check the LAN and

power connections.)

• If the Cable/DSL Router is configured correctly, check your Internet

connection. (DSL/Cable modem etc.) to see that it is working correctly.

5. I can’t obtain an IP address from my cable or DSL modem.

• Ensure that all of your cabling is properly connected and that all of the

router’s WAN and LAN LEDs are correctly illuminated.

• Power down your cable or DSL modem for a few seconds. Turn it back

on. After the modem goes through its self-test, check to see if you now

have an IP address.

• Ensure that your cable or DSL modem is DHCP-capable.

• You may have to enter the router or host name in the Setup page of the

Router’s web-based utility. Go to page 18 for more information.

• Your ISP may require Mac Addresses. Check with your ISP. This

address can be obtained in the Status screen of the Router’s Web-based

Utility.

BEFSR41 User Guide Apr 2000.qxd 4/27/00 3:21 PM Page 31