User guide

45
Maximum Performance Wireless-N Router
Linksys E4200 Chapter 2: Advanced Configuration
Status > Router
The Router screen displays information about the router
and its current settings.
Status > Router
Router Information
Firmware Version The version number of the router’s
current firmware is displayed.
Firmware Verification The unique identifier of the
firmware is displayed.
Current Time The local time is displayed.
Internet MAC Address The router’s MAC address, as seen
from the Internet, is displayed.
Device Name The Device Name is the NetBIOS name
of the router. The default is Cisco followed by the last 5
digits of the router’s serial number, which is found on the
bottom of the router. If you used the setup software for
installation, then the Device Name is the name of your
wireless network (up to 15 characters).
Host Name The Host Name of the router is displayed.
Domain Name The Domain Name of the router is
displayed.
Internet Connection
This section shows the current network information. The
information varies depending on the Internet connection
type selected on the Setup > Basic Setup screen.
For a DHCP connection, select Release IP Address or
Renew IP Address as appropriate to release or renew
a DHCP lease. For a PPPoE or similar connection, select
Connect or Disconnect as appropriate to connect to or
disconnect from the Internet.
Click Refresh to update the on-screen information.
Status > Local Network
The Local Network screen displays information about the
local network.
Status > Local Network
Local Network
Local MAC Address The MAC address of the router’s
local, wired interface is displayed.
Router IP Address The router’s local IP address is
displayed.
Subnet Mask The subnet mask of the router is displayed.
DHCP Server
DHCP Server The status of the router’s DHCP server
function is displayed.
Start IP Address For the range of available IP addresses,
the starting IP address is displayed.
End IP Address For the range of available IP addresses,
the ending IP address is displayed.
DHCP Client Table Click this option to view a list of
computers or other devices that are using the router as a
DHCP server.
DHCP Client Table
DHCP Client Table
The DHCP Client Table lists computers and other
devices that have been assigned IP addresses by
the router. The list can be sorted by IP Address, MAC
Address, Interface, and Client Name. To remove a
DHCP client, click Delete. To update the on-screen
information, click Refresh. To exit this screen and
return to the Local Network screen, click Close.