User's Manual

27
Setting Up: Advanced
Linksys E-Series
5. Complete the fields with information provided by your DDNS provider,
then click Save Settings. The Status field tells you what actions have
been taken.
In this example, the domain name registered with TZO.com is
BronzeEagle953.linksysnet.com. If an Internet camera had been configured
(see “How to set up port forwarding for a single port” on page 51), you
could access the camera by typing the domain name into the address bar
of your web browser followed by the port number used for the device.
For example, if the camera in the above example used port 1024, the URL
would be:
BronzeEagle953.linksysnet.com:1024
How to clone a MAC address
For
ALL
On any home network, each network device has a unique MAC (Media Access
Control) address. Some ISPs register the MAC address of the device (usually a
router or a computer) connected directly to the modem. If your computer’s
MAC address is registered with your ISP and you do not want to re-register
the MAC address, then you can clone the address (assign the registered MAC
address of your previous device to your new router). If you want to use the
MAC address from an old router that you are replacing with your new router,
you should first determine the MAC address of your old router, then manually
enter it into your new router.
NOTE
For many ISPs that provide dynamic IP addresses automatically, the
stored MAC address in the modem is reset each time you reset the
modem. If you are installing this router for the first time, reset your
modem before connecting the router to your modem. To reset your
modem, disconnect power for about one minute, then reconnect
power.
To clone a MAC address from your computer:
Setup > MAC Address Clone
1. Log into the browser-based utility (see “How to open the browser-based
utility” on page 22).
2. Click the Setup tab, then click the MAC Address Clone page.
3. Click Enabled.
4. Click either Clone My PC’s MAC or enter the 12-digit MAC address of
your old router.
5. Click Save Settings.