Smart Light Bars User Manual Model: KT-LT01MB
Package Contents x2 x1 Light Bars Base Type C-C Cable USB A-A cable POWER OUT R Smart Light Bars x2 x2 OUT L MIC MODE x1 Smart Light Bars User Manual x1 x1 Model: KT-LT01MB DATA External Power Supply DATA Control box DC IN User Manual
Specifications Power input (AC adapter) Tower 1 Tower 2 AC100-240V DC12V⎓1A White diffuser silicone, aluminum post and base, 38 RGB LEDs White diffuser silicone, aluminum post and base, 38 RGB LEDs Dimensions 376mm x 70mm x 70mm (without the headset holder) Water Resistance IP20 Control Method App, Control Box Luminous power 11W WiFi IEEE 802.11 b/g/n Bluetooth 4.0 Operating Frequency 2.412~2.484GHz Support System Android 5.0 or iOS 9.
Left light bar signal output Right light bar signal output Type C-C Cable Type C-C Cable POWER OUT R OUT L MODE MIC DATA DATA HDMI sync box data transmission interface Power Mode Power button Mode selection button DC IN Power input interface Press on/off button Long press the power button for 5 seconds to start the network distribution. Press mode button switch the Smart Light Bars Light mode.
Installing Steps 1. 2. 3. 4. Remove Light bars from Starter Kit box. Use the type c-c cable to connect the OUT L and OUT R of bars. Insert power supply to DC IN. Press power button start the smart light bars. How to distribution network: Preparation 1.Connect to 2.4GHz Wi-Fi network and turn Bluetooth on from you mobile phone. 2. Install the “Smart life” app from the Apple Store / Google Play Store. 3. Register an account and allow the app to use Bluetooth.
Prepare the control box Connection 1. Charge and turn on power button of contor box. Smart Light Bars 2. The indicator will flash quickly in green. Breathing flashing Power Add the control box to Smart Life The lamp will appear automatically waiting to be added when you open the Smart Life App. 1. Click "Go to add". 2. Select the contor box.
3. Enter 2.4GHz Wi-Fi network name and password, then tap "Next". Customer Service Warranty: Support: Email: Official Website: 4.
FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Non-replaceable light source. Not intended for illumination. Only used for creating ambiance. 1. Do not connect the rope light to the supply while it is in the packing or wound onto a reel; 2. Do not use the rope light when covered or recessed into a surface; 3.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
