Full Product Manual

2 Removing the mounting plate
NOTE: This fixture comes with a mounting plate (D). It is pre-assembled on the light
xture (B) for shipping.
Unscrew the decorative screw (CC) in the bottom of the xture (B), and pull the
mounting plate (D) from the xture.
3
Installing the mounting plate
Place the mounting plate (D) against the mounting surface and ensure the mounting
plate (D) is level.
Drill two holes (1) through the mounting plat
e (D) and into the mounting surface.
If mounting to a wooden surface, install the two mounting screws (AA) through the
mounting plate (D) and into the mounting surface.
If mounting to wall board or brick, remove the mounting plate (D) and drill the
mounting surface using the drill bit. Insert the wall anchors (BB) and attach the
mounting plate (D) using the two mounting screws (AA).