Instruction Manual
i
Table of Contents
Section 1 Introduction ....................................................... 1.1
Section 2 Parameter Entry and Access Control .................................... 2.1
Section 2.1 Parameter Entry ................................................. 2.1
Section 2.1.1 Numeric Entries .............................................. 2.1
Section 2.1.2 Text Entry .................................................. 2.1
Section 2.2 Access Control .................................................. 2.3
Section 2.2.1 Key Only Mode .............................................. 2.3
Section 2.2.2 Key or Password Mode ........................................ 2.3
Section 2.2.3 Password Only Mode .......................................... 2.4
Section 2.2.4 Key and Password Mode ....................................... 2.4
Section 2.2.5 Tonnage Monitor Restricted Items ............................... 2.4
Section 2.2.6 Access Control Operation ...................................... 2.4
Section 2.2.6.1 RUN/PROG Key Switch Operation ........................... 2.4
Section 2.2.6.2 Password System Operation ................................. 2.5
Section 3 Configuration ...................................................... 3.1
Section 3.1 The Main PLC Interface Configuration Screen ......................... 3.2
Section 3.2 Screen Status Message Configuration ................................ 3.3
Section 3.3 Parameter Status Message Configuration ............................. 3.5
Section 3.4 Parameter Configuration .......................................... 3.6
Section 3.5 PLC Screen Softkey Configuration .................................. 3.8
Section 3.6 Screen Status Label Configuration .................................. 3.9
Section 4 Operation ......................................................... 4.1
Section 5 Communications Protocol ............................................ 5.1
Section 5.1 Conventions .................................................... 5.1
Section 5.2 Acknowledgments ............................................... 5.1
Section 5.3 Numeric Value Formats ........................................... 5.1
Section 5.4 Text Value Formats .............................................. 5.2
Section 5.5 Commands From Link Equipment to PLC ............................ 5.2
Section 5.5.1 Job Number Command ........................................ 5.2
Section 5.5.2 User Parameter Command ...................................... 5.3
Section 5.6 Requests From the PLC to Link Equipment ........................... 5.4
Section 5.6.1 Request for Job Number ....................................... 5.4
Section 5.6.2 Request to Change Job ......................................... 5.5
Section 5.6.2.1 Load Job From Local Storage ................................ 5.5
Section 5.6.2.2 Loading a Job From LinkNet ................................. 5.5
Section 5.6.3 Request for User Parameter Value ................................ 5.6
Section 5.6.4 Request for Machine Parameter Value ............................ 5.6
Section 5.7 Machine Parameter Reference ...................................... 5.7
Section 5.7.0 Parameter 000 - RUN/PROG Switch Position ...................... 5.7
Section 5.7.1 Parameter 001 - Current User ................................... 5.7
Section 5.7.2 Parameter 002 - Month ........................................ 5.7