User guide
August 30, 2002 Manual Version 1.0
5.18
In order for the job notes to be saved after editing, the current job must be stored. Job storage is
described in Section 4.5.1.
Section 5.5.4 Auxiliary Communications
The AUXILIARY COMM softkey will provide access to communication options. These options
include communication with electronic servo feeds, auxiliary equipment (such as PLCs), a laptop
interface for downloading messages, and a network interface. A separate manual will be provided when
these options are supplied. See the manual pertaining to the particular device that is connected for
communication.
Section 5.5.5 LOGOUT Softkey
Selecting the LOGOUT softkey will remove access control from the current user. If a user has logged in
using the password system, this user will retain access control until the user is logged out. Log out can
be either manual or automatic. A user can be manually logged out by using the LOGOUT Softkey.
Automatic log out is described in Section 3.
Section 5.6 Job Setups (Storage and Recall)
From the Main Menu, Figure 5.1, pressing the JOB SETUPS softkey accesses the Jobs menu, Figure 5.9
and allows the user to access the internal file system of the operator terminal. The parameters for all job
related settings for standard and optional functions for the OmniLink II Press and Automation Control
can be stored once initially determined and recalled each time the job is run in the press. This allows
paperless record keeping of PLS/ Logic Module settings, Serial Feed Interface settings, Tonnage and
Signature Monitor settings, Die Protection settings, Analog Process Monitor settings, Automatic Setup
Module settings, etc.. This feature can give consistent setups of the press, auxiliary equipment, and
process monitoring items. It can also save a tremendous amount of time in setting up a complex
production system.
1.
Figure 5.9 Jobs Menu
Stroke
Mode
Single Stroke
Drive
Speed
Stroke
Speed
SPM
SPM
0
0
Order
Counter
PC STATUS
Counter O FF
JOBS
NEXT
GROUP
EXIT
0
0
READY TO STROKE
TOP
LAST
GROUP
RECALL
SETUP
STORE
SETUP
ERASE
SETUP
JOB NUMBER DESCRIPTION
000000001 FIRST EXAMPLE
000000002 SECOND EXAMPLE
000000003 THIRD EXAMPLE
000000004 FOURTH EXAMPLE
000000005 FIFTH EXAMPLE
000000006 SIXTH EXAMPLE
000000007 SEVENTH EXAMPLE
000000008 EIGHTH EXAMPLE
000000009 NINTH EXAMPLE
000000010 TENTH EXAMPLE
000000011 ELEVENTH EXAMPLE
000000012 TWELTH EXAMPLE
000000013 THIRTEENTH EXAMPLE
000000014 FOURTEENTH EXAMPLE
123456789 TWENTY CHARACTERS
Current Job:
Job Number Description
000000001 FIRST EXAMPLE
1
2
These softkey Legends
appear only with the
Program/Run switch in
Program position when
Key Only access to
Program mode is chosen
in the configuration menu.