Owner's manual

OmniLink 5000 Feed Manual December 13, 1999
1.2 Manual Rev 2.3
 The roll feed must be supported by the
OmniLink 5000. Supported feeds at the time
this manual was published include:
 Coe CPEC/BG1
 Coe BG2 **
 Coe ServoMaster **
 Dallas (EXOR Control) **
 Dynamic Feeds **
 Reliance/Electro-Craft IQ2000/IQ5000
 Emerson Roll Feed
 Indramat CLM/SOT/DLC
 Indramat CLM/SOT Ver 1.2 **
 CWP ServoDial II **
 CWP ServoDial 2000
 CWP Servomatic **
 CWP ServoMax II **
 PA Edge/Bullet/Advantage **
 RapidAir Feed
 Rowe (IQ2000/5000 Based)
 Unico Type 1
 Unico Type 2
 Vamco Feeds (except Pulsar)
 Waddington Feed
** = Feed supported only on new
communications card.