Owner's manual

• Reports are generated using Seagate Software Crystal Reports. This allows the end user to
customize (with separate purchase of Crystal Reports from any software vendor) LinkNet 2
reports for any special requirements, add a company logo, etc.
• Preventive Maintenance setpoints can be set by elapsed time, press running time, and strokes.
OmniLink 5000 controls additionally support setpoints by “Motor On” time, Total feed length,
and Clutch/Brake engagements.
• Tonnage signatures can be sent from OmniLink 5000 and System 1100 tonnage monitors to the
network for analysis, storage, or printing. Previous signatures can be overlaid for direct
comparison.
• Notes for each machine and die can be entered at the computer and viewed on OmniLink 5000
operator terminals.
1.2 System Requirements
LinkNet has been designed to run on Windows 98, Windows ME, Windows NT, or Windows 2000
operating systems.
Minimum Hardware Requirements:
• Pentium III or Celeron 500MHz CPU
• Windows 98 Operating System
• 64MB memory
• 10GB hard drive
• SVGA (800 by 600) display
• Mouse
• At least one free RS232 serial port
Recommended Hardware:
• Pentium III 800MHz CPU or better
• Windows 2000 Operating System
• 256MB memory
• 20GB or larger hard drive
• SVGA (1024 by 768) display or better
• Mouse
• At least one free RS232 serial port
Manual Version 1.1 10/28/2001
1.2