Installation Guide

3
www.linkinteractive.com • 1-877-826-5443
TIPS
Here are some important sensor setup guidelines to help your system
perform best.
PLACEMENT DISTANCE
All sensors should be placed within 80 feet of the control panel.
WHERE NOT TO PLACE
Sensors are not weatherproof, and should be kept indoors. Avoid placing in
high-humidity areas.
PREP THE SURFACE
Before mounting any sensors using the included adhesive, make sure the
surface to which you are adhering the sensor is clean and dry. Dampen a
paper towel or rag to wipe the surface, and then go over the area with a
dry one.
PRESS AND HOLD
After removing the backing from the adhesive and placing a sensor on a
surface, be sure to press it rmly in place and hold for 30 seconds.
ANCHORS
Use the included anchors to ensure the sensors don’t fall off.
VIDEOS
We have installation videos that provide you with step-by-step
instructions. Check out our resource center at
www.linkinteractive.com/installation-guide/
Important Note: Your system will only contain the components you ordered at
the time of purchase.
NEXT UP
Now that you’ve learned some pro tips
you’re ready to start placing your sensors.