Installation Guide
10
SMOKE/HEAT/FREEZE SENSOR
The Smoke/Heat/Freeze Sensor
detects smoke or rapid changes
in temperature in your home.
Like all of our life safety and
environmental sensors, your
Smoke/Heat/Freeze Sensor is
always monitored, even when
your system is disarmed.
PLACE: For maximum coverage,
place your Smoke/Heat/Freeze
Sensor on the ceiling or wall of
a common hallway shared by
multiple bedrooms or a central
room in the home.
If placing on the ceiling, position sensor in a central spot 4 inches away
from the wall. If placing on the wall, position 4 to 12 inches below the ceiling.
Do not place the sensor in any of the following areas: in a kitchen or garage,
near a ventilation source such as an exhaust fan, near a shower or other
potentially humid areas, near a furnace, space heater or hot water heater.
STEP 1
Remove the smoke detector from its base by twisting it counterclockwise.
Use the two screws to secure the base to the ceiling or desired location
(g 1). Then t the smoke detector inside the base (g 2).
STEP 2
With the Go!Control panel in SYSTEM TEST, press the detector’s “Test Hush”
button for approximately 10 seconds, continue to hold down the button until
you hear 4 sets of short beeps (g 3). Release the button after the beeps
have sounded. Lastly, verify that the signal was received at the control panel.
NEXT UP
Get notied if there is a disaster in your home.
fig 3
fig 1 fig 2
2
1
www.linkinteractive.com • 1-877-826-5443