Installation Guide

8
MOTION SENSOR PLACEMENT
Step 2
Install the wall mount so
its center is placed 7.5 to
8 feet above oor level.
Step 3
Place the back cover onto the
Motion Sensor and secure it with the
included screw (g 1). Then extend the
arm until it points straight out. Slide
the Motion Sensor onto the wall mount
(g 2). You may have to adjust the arm
based on preferences. Once the unit
is mounted, walk through the sensor’s
coverage area and listen for the sensor
name to be announced at the panel.
Note: In order to save battery power, the
motion sensor rests for 3 minutes after
sending a signal before sending a signal again.
While you are testing the sensor, please keep
in mind this 3-minute resting period. For the
sensor to reset it must sit idle for 3 minutes
with no motion detection.
NEXT UP
Got a Glass Break Sensor?
See where to place it.
**
fig 1
fig 2
www.linkinteractive.com • 1-877-826-5443