Owner's manual

Page
7.
20. Install the remaining small band clamp
onto the hump hose.
21. With the lter aimed upwards, slide the
tube into the hump hose and then rotate the
lter and tube assembly down 180 degrees into
position.
22. Position the assembly so that the inlet tube
is straight.
23. Push the lter against the factory radiator
shroud and then, using a 6 mm nut driver
or socket, tighten the clamp onto the lter.
Leave the clamp on the other end of the tube
loose. Make sure you have roughly equal hose
engagement on both sides of the air intake
duct. You should have just enough for each
hose clamp on each side.