Owner's manual

Page 6.
16. Make sure the tting on the hose is cocked
as shown in the image and then using a 7 mm
nut driver or socket, tighten the hose clamp in
place.
17. Inspect the air lter to make sure no
rubber debris or other material is inside the
lter.
18. Install the supplied air duct tube into the
supplied air lter. The sensor boss for the
mass air ow (MAF) sensor should be facing
the driver side of the vehicle. The lter gets
installed on the end of the tube that is closer to
the MAF sensor boss as shown.
19. Place the larger clamp (100-120 mm, part
# 539100120) onto the air lter neck. Note the
position of the clamp.