Owner's manual

Page
5.
12. Carefully remove the radiator shroud.
13. Using a 1/4” drill bit, drill out the plastic
shroud in the location that you marked in step
9. Re-install the modied shroud on the vehicle
and tighten down the four (4) bolts.
14. Install the barbed end of the supplied 45
degree plastic tting [part # 25862741] into the
tting on the hump hose.
15. Install one of the two smaller clamps (90-
110 mm, part # 53990110) onto the throttle
body side of the hump hose. Position the clamp
such that the tightening nut is on the passenger
side with the adjustment screw facing up.
Position the other hose clamps the same way.
Install the silicone hump hose onto the throttle
body. The hose is the same ID on both sides
so it does not matter which side of the hose is
connected to the throttle body.