Owner's manual

Page 4.
8. Remove the two factory airbox cover
mounting posts located in the radiator shroud.
Pull up on the center post of these fasteners to
loosen the tting and then remove the tting.
9. Temporarily place the LPE airbox cover on
the radiator shroud and insert a drill bit to locate
the hole as shown. Using a silver marker, mark
the location shown on the radiator shroud on
the driver side. This location on the radiator
shroud will be drilled out. Remove the airbox
cover.
10. Using a 10 mm socket and extension,
remove the two (2) bolts on the passenger side
of the radiator shroud.
11. Using a 10 mm socket and extension,
remove the two (2) bolts on the driver side of
the radiator shroud.