User Manual

Page
5. Loosen the band clamp on the factory air
cleaner housing using a at head screwdriver or
an 8 mm hex bit Allen socket.
6. Carefully remove the intake duct, be
careful not to let dirt or debris enter the intake
duct during the installation.
Steps 7-22 are for disassembling the airbox
to modify the bottom part of the air lter
houseing, which will reduce inlet restriction.
7. Using a T-25 Torx tool, remove the three
(3) Torx bolts from the top portion of the air
lter housing. The location of the rst bolt is
next to the power steering reservoir.
8. The location of the second bolt is located
in between the fender and the strut tower.
4.