Owner manual

Page 6 of 7
Thoroughly clean edge of airbox with supplied alcohol pad.
Cutthesuppliedfoamsealtotairboxasshowninimage.In-
stallrubbersealtothreeedgesofairboxasshown.Makesure
the foam seal does not interfere with the mounting holes.
Slideairboxandlterassemblyinplaceasshown.
Place the remaining 90-110 mm clamp on the hump hose and
connect the 4.0” hump hose to the throttle body. Push the
hosermlyasshowntoseatthehumphoseontothethrottle
body.Makesurethebottomisbutteduptothethrottlebody
ange.Tightentheclampsecurely.
Attach the breather hose to the plastic nipple in the hump
hose at this time.
For hood clearance reasons, the breather hose should be
clocked as close to the throttle body motor as possible.
Use four of the supplied push lock plastic rivet fasteners to
securetheairboxangetotheshroud.Pinchpiecestogether
as tight as possible while securing the fasteners.
From underneath the vehicle, starting with the bottom, center fastener, install the remaining seven supplied push
lock plastic fasteners, pinching pieces tight together while fastening.
Lookattheairlterfromunderneathatthistime,ifitisnotparallelwiththecutintheshroud,itmaybe
straightened now.