Owner manual

Page 5 of 7
Installthe3.9”straighthoseontheothersideoftheMAFsen-
sor.
Slide a 90-110 mm clamp over the straight hose section and
position the clamp as shown.
Slide another 90-110 mm clamp over the straight hose sec-
tion and attach the supplied plastic air-bridge to the other end
of the 3.9” hose with the nipple on the hump hose in the 10
o’clock position as shown.
Do not tighten the 90-110 mm clamp at this time.
Note position of logo on the air-bridge. As shown in the image,
the side of the plastic air-bridge that is closest to the LPE logo
(and not the Lingenfelter text) is the side that gets inserted
into the 3.9” hose.
RemovetheprotectivecoverfromtheLPEsuppliedairlter.
NOTE:Inspectinsideoflterforanydebrispriortoinstall-
ing in the vehicle. Be very careful during the remainder of the
installationprocesstonotletanydirtorobjectsfallintothe
lter.
Install the 100-120 mm clamp on the rubber neck of the air
lter.
Supportingthebottomoftheairlterwithonehand,insert
theendoftheairtubeassembly(“air-bridge”)intotherubber
neckoftheairlter.
Snug (not tighten) clamp.