Owner manual

Page 4 of 7
Install top radiator shroud ensuring it engages fan shroud in
the center as shown.
Tuck water hose back into holders on shroud, secure with four
bolts previously removed.
The following steps need to be done from underneath the
vehicle:
•Replace the previously removed four factory Christmas tree
fasteners retaining the shroud to the plastic side panels (two
per side).
•Replacetheve7mmheadscrewspreviouslyremoved.
Removethe3/8”barbedplasticquickcouplefromtheaccor-
dion section of your stock air intake system (see picture).
Installthequickcouplerintothesiliconehumphosebypush-
ing the barbed side into the 3/8” nipple on the hump hose. Do
not use lubricant.
Install 90-110 mm clamp over the notched side of the hump
hoseandinstalltheblackplasticsideoftheMAFsensorinto
the hump hose. Be sure to align the cut out notch on the
humphosewiththeprotrusionontheMAFsensor.
The clamp must be in the position shown and tightened at this
time.