User Manual

Page 8 of 9
InstalltheLPEhighowairintaketubeusingthe
largesthoseclamponthethrottlebodyendandthe
remainingsmallerhoseclampontheMAFsensorend.
Tightenthehoseclampsoneitherend,but do not
overtighten.
Removetheairlterfromitspackaging.Thislter
comespre-oiledandisreadytobeinstalled.
NOTE:Inspectinsideoflterforanydebrispriorto
installinginthevehicle.Beverycarefulduringthe
remainderoftheinstallationprocesstonotletanydirt
orobjectsfallintothelter.
Locatethe7/16”holepunchedintheblockrubber
sectionofyourairlter.Pushtheairtemperature
sensorthroughthishole,makesureitseatsushtothe
surface.Inserttheairlternoserstbehindtheairwall
previouslyinstalled.Theairtemperaturesensorshould
betowardstherearofthecar.Plugtheconnectorinto
theairtemperaturesensor.Afterpassingthelterall
thewayintothecompartment,connecttheroundend
oftheltertothehoseboltedtotheairwall.Thehose
clampontheendoftheltermightneedtobeloosened
inorderforthelterendtotthetube.Tightenthe
ltertosecurethet.