User Manual

Page 7 of 9
InstallMassAirFlowsensortothenewhosethathas
justbeeninstalled.Takecaretoinstallthesensorwith
theowarrowpointingtowardtheengine.Thearrow
shouldbepointingawayfromtheairwallandtoward
thenewtube.Massairowshouldalsobeinstalled
sothatthesocketontheMAFthathousestheMAF
connectorispointingtowardthecabinofthecar.
TightenclampconnectingMassAirFlowsensortohose.
Donotovertightenclamps.
ReinstallEngineCoolantcontainertoitsoriginalspot
intheenginecompartment.Makesureallhosesare
stillconnectedandtherearenoleaksasaresultofthis
installation.
PlugintheconnectorfortheMAFsensor.Nowfeed
theairtemperaturesensorconnectorthroughthe3/4”
holeintheairbox,pullalloftheslackintothebox.At
thepointwheretheharnessintersectsthebox,installthe
2”pieceofloomandworkthegrommetintoposition.
Thegrommethasaslotcutinitforinstallation.Using
WD40onthegrommetwilleasetheinstallation.