User Manual

Page 2 of 9
Read the entire instruction manual before beginning installation. Some stock parts
will be used in reassembly.
Installationshouldtakelessthanonehourwiththepropertools.Beforeinstallationsettheparking
brakeandopenthehoodofthecar.Ifcarhasbeenusedrecentlyyoumaywanttomakesuretheengine
hashadtimetocoolbeforebeginninginstallation.
Nextremovetheairtemperaturesensorfromthestock
airtube,beingcarefulnottoharmthesensor.Setthe
sensorasideatthistime,itwillbere-usedlater.
Firstremovetheplasticradiatorcoveronthefrontoftheenginecompartmentusingaathead
screwdriverandaprytool.Useascrewdrivertoprythecenternailofthepushfastenerupwardabout
halfaninch.Theprytoolwillthenbeusedtofullyremovethesefourpanelpinsandfreetheplastic
panelfromthebody.