Owner's manual

Lingenfelter PWM-001 Delivered Torque Limiter

Wires:

Blue = PWM signal output

Green = PWM signal input

Black = Battery ground

Red = +12V key on power

Switch settings

0 = 81%

1 = 82%

2 = 83%

3 = 84%

4 = 85%

5 = 86%

6 = 87%

7 = 88%

8 = 89%

9 = 90%

A = 91%

B = 92%

C = 93%

D = 94%

E = 95%

F = Pass Thru

Note: The green LED inside case will come on when the processor is functioning.

L460021105 PWM-001 Programmer instructions V 3.1.doc

PAGE 1
Lingenfelter PWM-001 Delivered Torque Limiter Wires: Blue Green = = PWM signal output PWM signal input Black Red = = Battery ground +12V key on power Switch settings 0 = 81% 1 = 82% 2 = 83% 3 = 84% 4 = 85% 5 = 86% 6 = 87% 7 = 88% 8 = 89% 9 = 90% A = 91% B = 92% C = 93% D = 94% E = 95% F = Pass Thru Note: The green LED inside case will come on when the processor is functioning. L460021105 PWM-001 Programmer instructions V 3.1.
PAGE 2
Remove the 4 screws that retain the cover. Inside the module you will find a rotary switch. For most applications, start with the indicator inside the PWM-001 set to the “B” (92%) setting and decrease to “B” or “A” if the “Stability Control” message still appears on your dash. On most vehicles, the delivered torque diagnostic is set when the delivered torque exceeds 92%. Consult your vehicle specific diagnostic information to determine the correct setting.