Owner's manual

Page

21. Locate the 13mm bolt above and slightly

in front of the hood release. There is a brace that

holds the wiring harness to the frame. This must

be removed to relocate the wires away from the

spring on the clutch return spring bracket.

22. Locate the bolt on the frame that is

indicated. There is a nut on top of the frame that

must be loosend to allow the bolt to drop down.

Using two (2) 13mm wrenches or sockets, loosen

the bolt so that you can hook the end of the

spring around it as shown.

23. Pull the bracket and secure it around the

clutch pedal. Using a 1/8” hex key, tighten the

set screw to the pedal and install the retaining nut

onto the set screw.

20. Disconnect the ambient inside temperature

sensor from the lower dash panel.