User Manual

Page 5.
12. Verify that the shift knob is properly aligned.
Then, applying constant downward pressure
on the shift knob, tighten the three (3) 5mm
set screws in a uniform manner to secure
and center the shift knob onto the gear
lever.
NOTE: Make sure to maintain the proper
shift knob alignment as you are tightening
the set screws.
13. Screw the LPE shift knob boot adapter onto
the shift knob. The tapered surface of the
collar can be difcult to get ahold of, so it
may be necessary to screw on the collar
from the inside of the shift boot, as shown in
the adjacent picture.
14. Orient the shift boot to it’s proper position.
The shift boot can be rotated around the
collar, even with the zip-tie already installed.
Then using a Phillips head screwdriver,
reinstall the four (4) shift boot mounting
screws.
15. Reconnect the electrical connector on the
back of the front oor console front cover.