Upgrade Kit v1.0 User guide

Page 6.
13. If a manual overide switch is not being
installed, install the plug seal into the end
of the supplied connector, and close the
retainer clip on the connector.Then install the
connector on to the single connector that is on
the harness.
If you are installing a manual overide switch,
skip to step 14.
14. If installing a manual override switch, crimp
the female terminal onto 16 gauge wire and
make sure the seal is crimped under the large
tangs on the terminal. Then push to seat
the terminal into the connector and close the
retaining clip. Run the wire to a switch rated
for at least 15 amps, and connect that switch
to either an always hot, or accessory power
source that uses a 15 amp fuse.
If not installing a manual overide switch, skip
to step 15.
15. Install the new VariMax intercooler pump
harness onto the factory intercooler pump
mounting bracket by inserting the end of the
wire loom retaining clip back into the bottom
hole of the mounting bracket. Make sure to
push the retaining clip through the hole as
far as you can to ensure that the harness is
securely fastened to the vehicle.
16. Plug the 2-way harness connector into the
new VariMax intercooler pump harness.