Upgrade Kit v1.0 User guide

Page 4.
5. Locate the connector on the rear of the
intercooler pump body and disconnect it by
pinching the metal clips while pulling away
from the pump.
6. Using a 13mm socket, ratchet, and extension
if necessary, remove both M8 nuts that hold
the Adel clamps to the factory mounting
bracket.
7. Remove the intercooler pump from the
mounting bracket, which will expose both M8
mounting studs, as well as the end of the wire
loom retaining clip.
8. Using a pair of hose clamp pliers, loosen the
hose clamp on the outlet hose. Disconnect
the outlet hose from the intercooler pump and
let the hose drain into a bucket.