Instruction Manual

Page
not be installed, in order to maintain a water
tight seal on the connectors, place the
plug seals into the connector and close the
retainer and connect it to the harness.
59. Position the three fuse holders as follows:
the two orange wired fuses will be on the
backside of the radiator support cross
member and the one red wired fuse will be
on the outside sheet metal beside the fuse
block.
60. Mark the holes and drill them using a 3/16”
drill bit.
61. Insert the 15 amp fuses into each of the
17.
and insert the three bolts and make sure
the four tabs on the perimeter are engaged.
Tighten the three bolts to 89 lb-in (10 Nm).
58. If the optional manual override switch will