Instruction Manual

Page
42. Undo the power terminal using a 13mm
socket, and connect the one red and two
orange wires from the harness there. Put
the nut back on the stud and torque it to 11
lb-ft (15 Nm).
43. Neatly route the wires so the TBRC-001 is
beside the fuse block.
44. Using a 13mm wrench, undo the ground
stud to the rear of the fuse block.
13.
41. Run the long tail of the wiring harness, the
part that is inside the engine bay, between
the fuse block and fender.