Instruction Manual

Page
29. Next is cutting the passenger side shroud,
the one holding the air temperature sensor.
Cut the part as shown here.
Then sand the part to smooth out the edges,
and round the lower corner by the mounting
hole as shown by the arrow.
30. The cut the driver side shroud as shown.
Then sand the part to smooth out the edges,
and round the lower corner by the mounting
hole as shown by the arrow.
31. Install the bottom air dam as shown, and
push in the plastic retaining clips as marked.
32. Unwrap the wiring harness
(PN:XX05636-0002) and inspect it for
damage. Then rotate the three relays so
they are all aligned in the same direction.
10.