Owner's manual

Page 8
20. Remove the remaining bolt, located on the
passenger side of the vehicle, that secures
the OEM PS cooler to the front bumper
impact bar.
17. Locate the power steering (PS) hose bracket
that is found where the PS lines cross under
the intercooler radiator and engine radiator
on the driver side. Using hose clamp pliers
to relieve the tension on the clamps, slide
the hose with the attached clamps off of the
metal lines and drain the uid into a basin.
Note: Power steering systems are very
sensitive to dirt. Do not re-use the uid you
have removed. Dispose of the uid properly.
19. Using a 13mm wrench, remove the bolt on
the passenger side power steering cooler
bracket.
18. Using a 10 mm wrench undo the bolt
holding the bracket for the PS hoses.