Owner's manual

Page
5
5. Open the hood and remove the six plastic
retainer clips from the sight shield by turning
the clips counterclockwise. Remove the
sight shield
6. Using a fork tool, remove the two (2) push
fasteners from each side (four total) that
secure the front fascia to the vehicle.
7. Remove the two M6x1.0 screws that secure
the fascia to the bumper core support using
a 10mm socket
TIP: It may be easier to access the screws
using a universal joint socket adapter and
an extension.
8. The front air deector is located on the
underside of the vehicle and is attached to
the front fascia and the front portion of the
frame. Remove the two (2) M6 bolts with a
10mm socket and then remove the 10 push
pins and remove the cover.
Note: The foam insert may come loose from
the panel. Be sure to retain the insert and
note its location so that it gets put back in
the correct location during re-assembly.