Owner's manual

Page
25
85. Connect the TBRC-001 relay controller to
the 6 pin connector.
86. Set the activation temperatures and sensor
type. Recommended temperatures are
90 degrees F for fans on low and 110
degrees F for fans on high with a 10 degree
hysteresis as shown in the picture to the left.
Temp 1: 0 on the x100 and 9 on the x10
Temp 2: 1 on the x100 and 1 on the x10
Hysteresis: 1 on the 16 position switch.
87. Hold the TBRC-001 to a suitable location
on the strut tower and clean that area
well using brake clean or equivalent. The
mounting area should be a at surface in
order for the hook and loop tape to secure
properly to the surface and to the TBRC-001
module.
88. Stick one side of the hook and loop tape to
the TBRC-001.