Owner's manual

Page
23
77. Insert one end of each of the two supplied
brass barbed unions (PN: LN-TT23) into the
ends of the power steering hoses that are
attached to the power steering cooler.
78. Slide one piece of the supplied shrink tubing
over each hose section and then install one
17mm Oetiker clamp (PN: 52545K55) onto
each of the hoses. Use the Oetiker pliers to
secure the brass barbs into place.
79. Connect the OEM power steering hoses,
from the rack and P/S pump, to the brass
barbs. Using a pair of hose clamp pliers,
release the tension from clamps and slide
the hose and clamps into place. These
clamps are attached to the hose and cannot
be moved or rotated.
Use a heat gun to secure the heat shrink
tubing to the loom and hose as before.
80. Now route the fan harness inside the engine
compartment to the driver side of the fuse
block and windshield wiper uid bottle ll
neck.