Owner's manual

Page
11
29. Remove the intercooler radiator and center
punch the hole locations you marked in the
previous step. Drill the four (4) mounting
holes using the supplied #2 carbide drill bit.
30. Hold the intercooler radiator back up into
place and attach it to the vehicle using the
four (4) supplied 1/4-20x3/4” thread forming
screws (PN: 1132408). Tighten the screws
in place using a 3/8” socket and wrench.
Torque to 5 lb-ft (7 Nm).
31. Using a 3/4” wrench, install the coolant
temperature sensor (PN: 12608814) into
the top rear hole on the driver’s side of the
intercooler radiator. Tighten to 14 lb-ft (20
Nm).
32. Apply a light coating of oil or o-ring safe
assembly lubricant to the threads of the 3/4”
push to lock 90 degree ttings (PN: SET22-
M22PL1290). Install the two ttings into the
intercooler radiator.