Owner manual

7
Boot Error Codes ($0080..$00BF)
Error
Description
Cause
Action
$0081
RAM failure.
Indicated by the following flashing LED’s on
FlashScan’s front panel.
Each time FlashScan or AutoCal is powered
up, it tests its external RAM chip. If that test
fails then the RAM chip is faulty.
Return FlashScan or AutoCal to EFILive for
repair.
$0082
BOOT Block is not present or corrupt.
Indicated by the following flashing LED’s on
FlashScan’s front panel.
Internal
Contact EFILive if this error persists.
$0083
BOOT Block is the wrong size
Internal
Contact EFILive if this error persists.
$0084
Boot block CRC is incorrect.
Indicated by the following flashing LED’s on
FlashScan’s front panel.
Each time FlashScan or AutoCal is powered
up, it tests the internal boot block software for
consistency. If that test fails the device will
not operate correctly.
Return FlashScan or AutoCal to EFILive for
repair.
$0085
Application firmware is not present or
corrupt.
Indicated by alternately flashing orange
LEDs on FlashScan’s front panel.
Each time FlashScan or AutoCal is powered
up, it tests the firmware for consistency. If
that test fails the firmware is invalid.
See Deadpoll mode below.
Reprogram the firmware.
Contact EFILive if this error persists.