Owner's Manual

T-SERIES OPERATOR APPLICATIONS:
Drawbar operators are for commercial and industrial use
on sectional overhead doors which use horizontal track
with normal radius. A draw bar operator is not suitable for
doors with high lift exceeding 24 inches or vertical lift
doors. The installation requires a minimum clearance of 5
inches above the high arc of the door (the highest point
reached by the door at any part of its travel). For back-
room requirement refer to Figure 20, Page 17. When
properly installed a drawbar operator effectively locks the
door in the closed position.
The T-Series drawbar operators are used in the
following applications:
-Continuous Duty, Medium Cycle Commercial
installations only
-Indoor Use Only
-Up to 22 foot high doors with a maximum area of 480
square feet for 3/4 HP, 280 square feet for 1/2 HP and
200 square feet for 1/3 HP - maximum area slightly
higher for lighter doors - consult factory
-Use with foam or pneumatic reversing edge door
components - REQUIRED where the 3 button station is
out of sight of the door or any other automatic, remote
or manual control is used to activate the door.
The purpose of this booklet is to provide assembly,
installation and operation information concerning Allstar T-
Series Commercial Vehicular Garage Door Operators and
related Accessory Products.
NOTICE
IT IS IMPORTANT THAT THIS INSTRUCTION
MANUAL BE READ AND UNDERSTOOD
COMPLETELY BEFORE INSTALLATION OR
OPERATION IS ATTEMPTED. IT IS
INTENDED THAT THE INSTALLATION OF
THIS UNIT WILL BE DONE ONLY BY
PERSONS TRAINED AND QUALIFIED IN
THE INSTALLATION, ADJUSTMENT AND
SERVICE OF COMMERCIAL OVERHEAD
DOORS AND DOOR OPERATORS AND BY
QUALIFIED ELECTRICIANS.
NOTICE
THE IMPORTANT SAFEGUARDS AND
INSTRUCTIONS IN THIS MANUAL CANNOT
COVER ALL POSSIBLE CONDITIONS AND
SITUATIONS WHICH MAY OCCUR DURING
ITS USE. IT MUST BE UNDERSTOOD THAT
COMMON SENSE AND CAUTION MUST BE
EXERCISED BY THE PERSON(S) INSTAL-
LING, MAINTAINING AND OPERATING THE
EQUIPMENT DESCRIBED HEREIN. DO NOT
USE THIS EQUIPMENT FOR ANY OTHER
THAN ITS INTENDED
PURPOSE - OPERATING OVERHEAD
COMMERCIAL VEHICULAR GARAGE
DOORS.
STANDARD FEATURES:
Limit Switches: Driven limit switches, easily adjusted over
a wide range. The motor may be removed without affecting
the limit switch adjustments
Manual Release: Permits manual operation of the door in
the event of a power failure.
Control Circuit: Standard three button open, close and stop.
24 Volts AC.
Connections For Auxiliary Entrapment Protection
Devices:
Use with foam or pneumatic reversing door edge
components or a photoelectric beam (across the opening)
devise.
Constant Contact To Close: Feature can be activated by
simply moving a wire on the terminal strip.
Momentary Contact To Open and Close: Standard
operation.
OPTIONAL FEATURES:
Digital Radio Controls: Open, Close and Stop operation.
Radio units are available to control up to 27 doors from one
transmitter
Digital Timer to Close: Adjustable from 0 to 17 minutes
in one second intervals.
Keyless Entry System: Connection terminals provided for
hard wired or wireless keyless entry system.
Brake: Optional on 1/3 & 1/2HP, Standard on 3/4HP.
Can be added in the field.
PRODUCT FEATURES
3