Owner's Manual

NOTE: It is now necessary to turn on the power in
order to run the Opener to check for proper operation
and limit settings. Before doing so, ensure that all mounting
hardware is installed and has been properly tightened, that all
electrical connections are per local code requirements, and that
proper wiring practices have been followed. Also, double-check
that all ropes have been removed from the door and that the
doorway is clear.
IMPORTANT SAFETY INSTRUCTIONS FOR OWNER
• NEVER let children operate or play with door controls. Keep the Remote Control away from
children.
• ALWAYS keep a moving door in sight and keep people and objects away from the door area
until the door is completely closed. NO ONE SHOULD CROSS THE PATH OF A MOVING
DOOR.
• TEST THE DOOR OPENER’S REVERSING FEATURE (where applicable) MONTHLY. The
door MUST reverse upon contact with a 4” high object on the floor. After adjusting the
force setting (clutch) or the limit of travel, ALWAYS RETEST the Opener. Failure to ADJUST
THE OPENER PROPERLY may result in SERIOUS INJURY OR DEATH.
• DO NOT over adjust the force setting (clutch) to compensate for a poorly working door. See
page 16 for procedure to check the door operation and page 15 for proper clutch
adjustment.
• If possible, USE THE MANUAL RELEASE only when the door is closed. Use caution when
using the Release with the door open. WEAK OR BROKEN SPRINGS MAY ALLOW THE
DOOR TO CLOSE RAPIDLY, CAUSING SEVERE INJURY OR DEATH.
• KEEP THE GARAGE DOOR PROPERLY BALANCED. See the door owner's manual. An
improperly balanced door MAY CAUSE SEVERE INJURY OR DEATH. Have a QUALIFIED
SERVICE PERSON MAKE REPAIRS TO CABLES, SPRING ASSEMBLIES AND OTHER
HARDWARE. SAVE THIS INSTRUCTION MANUAL FOR END USER
TO REDUCE THE RISK OF SEVERE INJURY OR
DEATH: READ AND FOLLOW ALL INSTRUCTIONS!
WARNING
FAILURE TO TEST REVERSING
SYSTEM COULD RESULT IN DEATH
OR SERIOUS INJURY. TEST THIS
SYSTEM ONCE A MONTH.
WARNING
MOMENTARY CONTACT: Button can be pushed and
then released and door will keep moving or stop without
maintaining pressure on the button.
CONSTANT PRESSURE: Constant pressure is required
on the button in order for continued door movement. When
the button is released the door will stop and possibly
reverse to full open depending on wiring type.
DOOR EDGE/PHOTOELECTRIC INPUT: The
operator wiring provides for input from an optional
pneumatic or electric door bottom edge or photoelectric
device that will cause a closing door to stop and may
reverse it to open depending on the wiring type.
OPEN OVERRIDE: When the door is closing a
momentary push of the OPEN button will reverse the door
to open.
WIRING TERMS
OPERATION & ADJUSTMENT INSTRUCTIONS
AVOID ELECTROCUTION:
DO NOT ROUTE LOW VOLTAGE WIRES IN
SAME CONDUIT AS HIGH VOLTAGE
WIRES. FOLLOW ALL LOCAL
ELECTRICAL CODES OR THE NATIONAL
ELECTRICAL CODE.
WARNING
13