Owner's Manual

Secured Series Proximity Reader Installation Instructions
Document # 6065700 Rev 1.1 D2c 11/23/04
5
Figure 3: Connecting a Third Party Wiegand Reader or Keypad to the Wiegand Interface
Module
BE SURE YOU ARE USING STRANDED/SHIELDED CABLE OF THE CORRECT GAUGE BETWEEN THESE UNITS.
To IEI
Door
Controller
To
Wiegand
Reader
Note: LED Control line is
at +12V normally and
goes low (Ground) when
IEI Door Controller Main
Relay energizes.
See note 2 on page 1.