Owner's Manual

Secured Series Proximity Reader Installation Instructions
Document # 6065700 Rev 1.1 D2c 11/23/04
4
Figure 2: Connecting the HID MaxiProx Proximity Reader to the Wiegand Interface Module
BE SURE YOU ARE USING STRANDED/SHIELDED CABLE OF THE CORRECT GAUGE BETWEEN THESE UNITS.
To IEI
Door
Controller
Represents length of
wire run. See page 1
for proper wire
gauge.
Note: If you don’t
have a TB2 on your
MaxiProx, on TB1
connect V+ to
terminal 3, Data 1 to
terminal 5 and Data 0
to terminal 4. These
are the connections
for the Rev. E
MaxiProx.
See note 2 on page 1.