Owner's Manual

CHAIN HOIST INSTALLATION

1. Refer to Figure 10 to install the chain hoist. Pass the

hand chain, item 13 over the chain pocket wheel and

through the chain guide holes on the operator clutch

shaft (opposite end from the large pulley). Fasten the

ends of the chain together (to make one continuous loop)

by opening and re-closing one link using two pairs of

pliers. If the chain is too long, shorten it to the desired

length by removing links.

2. After attaching sash chain, item 10, with tension spring,

(See Figure 9), pull the sash chain to engage the hand

chain. This will actuate the interlock switch and

disengage the solenoid brake.

3. Use lag screws to attach the disconnect bracket, item 11,

vertically in line with the sash chain about four feet off

the floor. See Figure 11.

BEFORE PROCEEDING WITH THE

OPERATOR INSTALLATION AND

SETTINGS, MAKE A FINAL CHECK FOR

TIGHTNESS OF ALL MOUNTING

HARDWARE AND SET SCREWS.

INSTALLATION INSTRUCTIONS

107174

Figure 11

Figure 10

107614