Owner's Manual

• Install only on a properly balanced garage door.
An improperly balanced door could cause severe
injury. Have a qualified service person make repairs
to cables, spring assemblies and other hardware
before installing the opener.
• Remove all ropes and remove or make
inoperative all locks (unless mechanically and/or
electrically interlocked to the power unit) that are
connected to the garage door before installing the
opener.
• Lightweight doors (fiberglass, aluminum etc.)
must be reinforced to avoid door damage. Check the
door manufacturer’s instruction manual for a bracing
procedure or the availability of a Reinforcement Kit.
• The MO Series Operator is a Commercial
Vehicular Door Operator and as such is NOT
recommended for pedestrian traffic. In installations
where it is known that pedestrians will be nearby
ensure a pedestrian door is available for entrance and
exit to the building. In addition YOU MUST install
an auxiliary entrapment protection device (reversing
door edge or photoelectric beam device) as part of the
complete operator system.
• Connect an auxiliary entrapment protection
device (reversing edge or photoelectric device across
the door opening). A device of this type is
TO REDUCE THE RISK OF SEVERE INJURY
OR DEATH: READ AND FOLLOW ALL
INSTALLATION INSTRUCTIONS!
WARNING
TABLE 1 - COMPONENT IDENTIFICATION LISTING
STRONGLY ADVISED FOR ALL commercial
operator installations. An auxiliary entrapment
protection device is REQUIRED when the three
button control station is out of sight of the door or
any other automatic or manual control is used.
• Install the opener at least 8 feet or more above
the floor.
• Do not connect the opener to the source of
power until instructed to do so.
• Locate the control station:
a) within sight of the door and;
b) at a minimum height of five feet
above the floor and;
c) away from all moving parts of the
door.
• Do not overtighten the clutch adjustment
(where provided) to compensate for a poorly
working door.
• Securely attach any WARNING signs or
placards to either the door or above the control
station as directed (see page 15).
• After installing the opener, all control features
must be tested for proper operation (see page 19).
Item # Part
Number
Description Qty. Item
#
Part
Number
Description Qty.
1 Per Model Operator Power Head 1 10 009149 Sash Chain 12 FT
2 Per Model Driven Sprocket on Door Shaft 1 11 105193 Wall Disconnect Bracket 1
3 006119 Set Screw, 5/16-18 x 1, Sqr Head 2 13 100315 Hand Chain, Precut @ 26 FT 1
4 Per Model Steel Square Key 1 14 105139 Mounting Bracket Optional
6 Per Model Drive Chain 1 15 107812 Wall Mounting Plate w/Studs Optional
7 Per Model Master Link 1 16 Per Model Drive Sprocket 1
8 005031 3 Button Station 1 17 006119 Set Screw, 5/16-18 x 1, Sqr Head 2
9 105531 Cotter Pin 1 18 100413 Key, 1/4 x 1/4 x 1 1
IMPORTANT INSTALLATION NOTES
5