Owner's Manual

Pre-Installation Notes....................................................3
Operator Class Designation ......................................3
Section A: Gate System Design/Installation..............4
Section B: Preparing the Site ......................................6
The Concrete Operator Pad.......................................6
Electrical Power Requirements ................................6
Placing the Vehicle Detector Loops .........................8
Section C: Installing the Operator ..............................9
Attaching the Chain Bracket......................................9
Placing the Leader......................................................9
Electrical Hookup........................................................ 9
Additional Lightning Protection Information...........9
Control and Accessory Equipment Wiring ............10
Bi-Parting Application ......................... 10, 17, 20,& 21
Optional Photoelectric Thru Beam Sensor ............11
Optional Photoelectric Retro-Reflective Sensor ...12
Optional Electric Edge Sensor ................................13
Wiring the Vehicle Detectors ...................................14
Wiring a 3 Button Station / Access System ...........14
Left or Right Hand Installations ..............................15
Setting the Limit Switches.......................................16
WARNING HIGH VOLTAGE
ONLY A QUALIFIED TECHNICIAN SHOULD SERVICE THIS GATE OPERATOR
PERIODICALLY TEST SENSITIVITY OF OVERLOAD *** READ MANUAL ***
DATES OPERATOR
DATE TESTED DATE TESTED DATE TESTED DATE TESTED
SERVICED
LOG DATE OVERLOAD TEST
READ THESE STATEMENTS CAREFULLY AND FOLLOW THE
INSTRUCTIONS CLOSELY.
The Warning and Caution boxes throughout this manual are there to protect you and
your equipment. Pay close attention to these boxes as you follow the manual.
WARNING
Indicates a MECHANICAL
hazard of INJURY OR
DEATH. Gives instructions
to avoid the hazard.
CAUTION
Indicates a MECHANICAL hazard
of DAMAGE to your gate, gate
operator, or equipment. Gives
instructions to avoid the hazard.
Indicates an ELECTRICAL
hazard of INJURY OR
DEATH. Gives instructions
to avoid the hazard.
WARNING
Indicates an ELECTRICAL hazard
of DAMAGE to your gate, gate
operator, or equipment. Gives
instructions to avoid the hazard.
CAUTION
Setting the Obstruction Detection.......................... 16
Setting the Switch Selectable Options .................. 17
No Load Test Mode .................................................. 17
Timer To Close Setting ............................................ 17
Section D: Starting the Operator .............................. 18
Indicator Lamps........................................................ 18
Final Setting of Limit Switches............................... 19
Final Setting the Close Timer.................................. 19
Final Setting - Obstruction Detection..................... 19
Testing the Operator Lock ...................................... 19
Maximum Run Timer (SMART)................................ 19
Final Setting - Bi-Parting Installation .................... 20
Terminal Strip Reference Chart ......................20 & 21
Wiring Diagram......................................................... 22
Testing the Vehicle Loop Detectors....................... 23
Section E: End User Instructions .............................. 23
Operational Guide for the End User....................... 24
Manual Operation of Gate ....................................... 24
Safety Guide for the End User ........................25 & 26
Replacement Parts View & Listing ......................... 27
Technical Specifications ............................................ 28
Figure 1
TABLE OF CONTENTS
2