Owner's Manual

OPERATION & ADJUSTMENT INSTRUCTIONS
NOTE: It is now necessary to turn on the power
in order to run the Opener to check for proper
operation and limit settings. Before doing so, ensure
that all mounting hardware are installed and properly
tightened, that all electrical connections are per local code
requirements, and that proper wiring practices have been
followed.
Also, double-check that all ropes have
been removed from the door and that the doorway
is clear.
IMPORTANT SAFETY INSTRUCTIONS FOR OWNER
NEVER let children operate or play with door controls. Keep the Remote Control away from
children.
ALWAYS keep a moving door in sight and keep people and objects away from the door area
until the door is completely closed. NO ONE SHOULD CROSS THE PATH OF A MOVING
DOOR.
TEST THE DOOR OPENER’S REVERSING FEATURE (where applicable) MONTHLY. The
door MUST reverse upon contact with a 4” high object on the floor. After adjusting the
force setting (clutch) or the limit of travel, ALWAYS RETEST the Opener. Failure to ADJUST
THE OPENER PROPERLY may result in SERIOUS INJURY OR DEATH.
DO NOT over adjust the force setting (clutch) to compensate for a poorly working door. See
page 16 for procedure to check the door operation and page 14 for proper clutch
adjustment.
If possible, USE THE MANUAL RELEASE only when the door is closed. Use caution when
using the Release with the door open. WEAK OR BROKEN SPRINGS MAY ALLOW THE
DOOR TO CLOSE RAPIDLY, CAUSING SEVERE INJURY OR DEATH.
KEEP THE GARAGE DOOR PROPERLY BALANCED. See the door owner's manual. An
improperly balanced door MAY CAUSE SEVERE INJURY OR DEATH. Have a QUALIFIED
SERVICE PERSON MAKE REPAIRS TO CABLES, SPRING ASSEMBLIES AND OTHER
HARDWARE.
SAVE THIS INSTRUCTION MANUAL FOR END USER.
TO REDUCE THE RISK OF SEVERE INJURY OR
DEATH: READ AND FOLLOW ALL INSTRUCTIONS!
WARNING
FAILURE TO TEST REVERSING SYSTEM
COULD RESULT IN DEATH OR SERIOUS
INJURY. TEST THIS SYSTEM ONCE A MONTH
.
WARNING
MOMENTARY CONTACT: Button can be pushed and then
released and door will keep moving or stop without maintaining
pressure on the button.
CONSTANT PRESSURE: Constant pressure is required on the
button in order for continued door movement. When the button is
released the door will stop and possibly reverse to full open
depending on wiring type.
DOOR EDGE/PHOTOELECTRIC INPUT: The operator
wiring provides for input from an optional pneumatic or electric
door bottom edge or photoelectric device that will cause a closing
door to stop and may reverse it to open depending on the wiring
type.
OPEN OVERRIDE: When the door is closing a momentary
push of the OPEN button will reverse the door to open.
WIRING TERMS
AVOID ELECTROCUTION:
DO NOT ROUTE LOW VOLTAGE WIRES IN
SAME CONDUIT AS HIGH VOLTAGE
WIRES. FOLLOW ALL LOCAL
ELECTRICAL CODES OR THE NATIONAL
ELECTRICAL CODE (NEC).
WARNING
13