Owner's Manual

International Electronics Incorporated Technical/Sales: 1-800-343-9502 , 1-800-733-9502
427 Turnpike Street Phone: [phone]
Canton, Massachusetts 02021 Fax: [phone]
Fax Information Center: 781-821-0734 www.ieib.com
HubPlus Kit Installation Manual
Part# 6065035 rev. 1.1
Fax Document Number: 5035
1
Secured Series:
Hub Plus Kit
Single Door Controller Package Installation Manual
This package is designed to simplify the connections to our Secured Series Hub Plus Controller. This
will translate into shorter installation times and increase your profits while at the same time increasing
the protection and reliability of the device. This manual will give you step by step guidance through the
installation.
Note: When installing the Hub Plus Kit do not refer to any wiring diagrams in the Secured Series Hub
Plus Controller Features, Programming and Wiring guide. They no longer apply when using this kit. The
programming instructions do apply.
Features:
• All plug in wire harnesses are connected and now accessible through terminal screws.
• All there is to do is connect the supplied transformer to the power supply.
• No more soldering.
• Has Com Line protection for port A and Port C making networking between buildings more reliable.
• On Board RJ11 jack that is jumper selectable makes connecting to a PC or Modem within 25 Ft easier.
• On-Board Loop-back connectors for faster and easier com port tests.
• Inputs for door contact and REX have components that make testing and operation easier.
Installation
q Step 1: Unpacking the device and checking the packing list.
q Step 2: Making the connections between the Front End Reader and the Hub Connection Board.
q Step 3: Making the connections for the REX and Door Contact.
q Step 4: Wiring the On-Board RJ11 Jack in the Hub Connection Board(for use with optional PC
Software, available in MS-DOS and Win95 versions).
q Step 5: Connecting the 16.5 VAC transformer and battery (not included) to the Power Supply.
q Step 6: System power up.
If you have disassembled the Hub Plus Kit and need to reconnect the Hub Plus
Controller follow the steps listed below:
q Step A: Mounting and disassembling the Hub Plus Controller.
q Step B: Making the connections between the Hub Plus Controller and Hub Connection Board.
q Step C: Reassemble the Hub Plus Controller.
q Step D: Connecting the Hub Plus Controller to the Power Supply.
q Step E: System power up.