Owner's Manual
6
IR CODE CONFIGURATION
3X1 Switcher For HDMI 1.3
Remote Channel 1:
Default
Remote Channel 4:
Remote
Remote Channel 1:
Default
1 2
Remote Channel 2:
1 2
Remote Channel 3:
1 2
Remote Channel 4:
1 2
How to Resolve IR Code Conicts
In the event that IR commands from other remote controls conict with the supplied
RMT-3IR remote control, changing the remote channel will alleviate this issue. The
RMT-3IR remote control and the 3X1 Switcher for HDMI 1.3 have DIP SWITCHES
for conguring the remote channel that both units use to communicate. These
settings must match each other for proper operation. The 2 DIP SWITCH bank on
the RMT-3IR is located underneath the battery cover. The 4 DIP SWITCH bank for
the 3X1 Switcher for HDMI 1.3 is located on the underside of the unit beneath a
black piece of metallic tape. DIP SWITCH 1 and 2 on the RMT-3IR correspond to
*DIP SWITCH 1 and 2 on the 3X1 Switcher for HDMI 1.3.
NOTE: *DIP SWITCHES 3 and 4 are not used on the 3X1 Switcher for HDMI 1.3.
1
1
2
2
3
3
4
4
Remote Channel 3:
1
2
3
4
Remote Channel 2:
1
2
3
4