Owner's Manual

6
IR CODE CONFIGURATION
2X2 Switcher for HDMI
Remote Channel 1:
Default
Remote Channel 4:
Remote
Remote Channel 1:
Default
1 2
Remote Channel 2:
1 2
Remote Channel 3:
1 2
Remote Channel 4:
1 2
HowtoResolveIRCodeConicts
In the event that IR commands from other remote controls conict with the supplied RMT-2IR
remote control, changing the remote channel will alleviate this issue. The RMT-2IR remote control
and the 2X2 Switcher for HDMI have DIP SWITCHES for conguring the remote channel that
both units use to communicate. These settings must match each other for proper operation. The 2
DIP SWITCH bank on the RMT-2IR is located underneath the battery cover. The 8 DIP SWITCH
bank for the 2X2 Switcher for HDMI is located inside of the unit. *DIP SWITCH 1 and 2 on the
RMT-2IR correspond to DIP SWITCH 3 and 4 on the 2X2 Switcher for HDMI.
NOTE: *DIP SWITCHES 1, 2, and 5 through 8 are not used on the 2X2 Switcher for HDMI.
Because the procedure for changing channels requires the main unit to be disassembled, this
procedure should only be done if there are IR conicts present in your setup.
Disconnect power from unit before starting. Remove all cabling from unit.
To open the 2X2 Switcher for HDMI Unit, remove all screws from the sides and underside of the
unit. Remove the hex nuts above each HDMI connector and on the RS-232 serial connector. Slide
the unit apart carefully to expose the internal PCB and the 8 DIP SWITCH bank.
When DIP SWITCH adjustments are complete, carefully slide the unit back together. Being careful
not to over tighten the hex nuts, screw them back in above each HDMI connector and on the RS-
232 serial connector. Screw all of the screws from the sides and underside of the unit back into the
unit, again being careful not to over tighten the screws. Plug all cabling back into its proper location
on the unit. Reconnect power to the unit and test for IR conicts.
1
2
3
4
5
6
7
8
Remote Channel 3:
1
2
3
4
5
6
7
8
Remote Channel 2:
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8