Quick Start Guide

6
Controller to Client Conversion
This section is for systems that contain multiple TE front ends on the same network.
By default each TE front end is congured as a controller. When multiple TE front ends are in the same network, only ONE can be the controller. All
others must be clients.
This step will need to be performed on all TE units that will NOT be the controller on the network. All EP-EXN’s are pre-congured as clients and do
not need to go through this step.
Note: All TE controllers and clients must be operating on the same software revision. System failure may occur if not updated to the same software revision. Refer to Nortek
Security and Control technical support for assistance in determining and/or updating the software revision.
1. Locate the panels MAC address.
Option 1: Locate on the control board and of the unit you are converting to a client. On the main PC board document the unit MAC address.
Option 2: Retrieve the MAC from the panel license page.
2. Log onto www.e3upgrade.com.
3. Click the License Now button.
4. Enter the last six (6) characters of the system MAC
address.
5. Click Next.