Owner's Manual

4
Hub and Power Supply Setup
The hub and power supply can mount on the grid in a Linear
structured wiring enclosure or to a universal mounting bracket
(Model H275). The bracket is included in the Model ENC-KIT-M
installation kit.
Structured Wiring Enclosure
If the hub and power supply will be mounted in a structured wiring
enclosure, follow these steps:
Determine a location for the structured wiring enclosure. Be sure power is 1.
available near the location to wire an outlet box in the enclosure.
Install a J-box in the enclosure and have a2. licensed electrician route
power to the J-box.
Install an outlet in the J-box and install an outlet cover plate.3.
➜ WARNING: Do not connect the power supply to the AC line
until after the installation is complete.
Mounting Bracket Installation
If the hub and power supply will be mounted on a Model H275
mounting bracket, follow these steps:
Determine a location for the mounting bracket. Be sure power is available 1.
near the location to wire an outlet box next to the mounting bracket
location.
Use four screws to mount the H275 bracket on a suitable mounting 2.
surface.
Have a3. licensed electrician install an outlet in a J-box near the mounting
bracket. Install an outlet cover plate.
➜ WARNING: Do not connect the power supply to the AC line
until after the installation is complete.
Hub and Power Supply Installation
The hub and power supply mount to the grid holes in the structured
wiring enclosure or on the universal mounting bracket.
Insert the hub into a set of grid mounting holes. Secure the hub with the 1.
snap lock retainer.
Insert the power supply into a set of grid mounting holes. Secure the power 2.
supply with the snap lock retainer.
Connect the power supply’s DC output cable to the hub. The cable has a 3.
push-on terminal block that connects to the hub’s POWER connector.
Zone Pairing
Zone pairing is optional. It allows simultaneous control of two or
more speaker zones. A typical use would be in large rooms with
multiple keypads and speakers. Paired zones can be controlled
from any keypad in the pair, each keypad and speaker zone will
perform identically.
Zone pairing is controlled by the SETUP switch on each hub.
Switch positions 5-8 select which zones to pair.1.
To pair two or more speaker zones, set the 2. SETUP switch position to ON
for any of the four speaker zones.
SWITCH # SPEAKER ZONE
5 ZONE 1
6 ZONE 2
7 ZONE 3
8 ZONE 4
Structured Wiring Enclosure MountingFigure 2.
MOUNTING
GRID
J-box Installed in Enclosure for AC PowerFigure 3.
J-BOX
OUTLET
INSTALLED
IN J-BOX
H275 Universal Mounting BracketFigure 4.
Hub and Power Supply Installation in CabinetFigure 5.